How do I reset my USG?

Resets to factory defaults. The UniFi Gateway should be powered on. Press and hold the Reset button for about 10 seconds until the right LED on the WAN 2 / LAN 2 port starts flashing and then becomes solidly lit. After a few seconds, the LED will turn off, and the UniFi Gateway will automatically reboot.

How do I factory reset my USG?

Quote from Youtube:
I'm Jamie and in this video I'll demonstrate how to perform a hard reset of the unified security gateway with the device powered on use a tool like a paperclip to press and hold the reset button.

How do I reset my SSH USG?

Press and hold the reset button located on the back of the device. 3. Keep the reset button pressed for more than 5 seconds, after some time the LED will start flashing white.

How do I reset my USG Pro?

To reset the Ubiquiti Networks USG-PRO-4 to its default settings, you have to do the following steps:

1. Turn on router.
2. Press RESET button and hold for at least 10 seconds.
3. Restart of the device is automatically executed.
4. Restoration of standard settings is finished.

How do I reset my UniFi USG password?

Changing or resetting your password

1. Go to account.ui.com and click Forgot password?
2. Enter the email address associated with your account and send yourself a password-reset email.
3. Click the link in the email to create a new password.

How do I reset my ubiquiti access point?

Restore to Factory Default Settings Press and hold the Reset button for more than five seconds. Alternatively, the UniFi AP may be reset remotely via a Reset button located on the bottom of the Gigabit PoE adapter.

How do I reset my ubiquiti router?

Performing a Software Reset

1. Navigate to the System tab in the bottom-left of the Web UI.
2. Reset the configuration to defaults by pressing the Reset to Default button in the Reset Config to Default section.
3. The EdgeRouter will prompt for a device reboot to complete the reset.
4. Wait for the reboot to complete.

How do I reset my Ubiquiti AP lite?

Follow the steps as outlined below:

1. Press and hold the reset button for 10 seconds.
2. Release the button (the LEDs on the UAP will stop glowing)
3. Do not disconnect the UAP from its POE injector during the reboot process.
4. The UAP will restore factory settings.

How do I reset my host key?

Unix host key change instructions

1. Run this command, replacing HOSTNAME with the name of the host you are connecting to: ssh-keygen -R HOSTNAME. …
2. Add the new key to your known hosts with the command: ssh HOSTNAME.
3. You should be prompted to add the key to your known_hosts file, as shown below.